For Ford OBD port relocation extension diagnostic dummy anti theft

These are made using new genuine Ford OBD ports. These ports are not normally available unless you purchase an entire wiring loom.

Fitting is this easy…..

Firstly unclip your original port and clip the dummy in its place. Then plug the red connector on the dummy into your genuine port. Close the locking clip to avoid loose connections and short circuits. Now relocate the original to a place of your choosing out of sight to a thief. Using the cable ties supplied strap the dummy lead to your cars wiring loom to make it look like the original port.

If connected to, the port will power up the criminals equipment but obviously will not be able to read data. He will think it’s the original port and that it has been somehow blocked so he will not think about looking for the original which you have relocated behind the dash – at this stage they are unlikely to hang around to hunt for it.

“If a criminal was to break into your car with the dummy port fitted the alarm would go off. They will connect their kit. It would power up just like the real port but nothing else would happen. They would not be able to turn off the alarm or release the doors dead locks. They won’t want to be climbing through the window into your car where they can’t make a quick getaway to work out why their kit isn’t working. Worst case scenario is you get a broken window but at least your car will not get stolen.”